User's Manual

The manufacturer is not responsible for any radio or TV interference caused by

unauthorized modifications to this equipment. Such modifications could void the

user authority to operate the equipment.

Cautions!

FCC Radiation Exposure Statement

This equipment complies with FCC RF radiation exposure limits set forth for an

uncontrolled environment.This transmitter must not beco-located or operating in

conjunction with any other antenna or transmitter. This equipment complies with

Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, includinginterference

that may cause undesired operation.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC rules.These limits are designed to

provide reasonable protection against harmful interference in a residential

installation.This equipment generates, uses and can radiate radio frequency

energy and, if not installed and usedin accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipmentdoes cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:-Reorient or relocate the receiving antenna. Increase the separation

between the equipment and receiver. Connect the equipment into an outlet on

a circuit different from that to which the receiver is connected. Consult the dealer

or an experienced radio/TV technician for help.To assure continued compliance,

any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate this equipment.

(Example use only shielded interface cables when connecting to computer or

peripheral devices).