User Manual

Mode:STA

WiFi IP:192.168.1.201

Encoder IP:192.168.1.111

Wireless Transmission Module Upgrading

1. The transmitter operates the same as the wireless software upgrade

of the receiver.

2. The back of each device’s body will be labeled with the IP address of

WiFi and the IP address of the encoder/decoder. The default IP

addresses are as follows:

(Take the following figure as an example: The device’s operating mode,

WiFi IP(wireless transmission module IP), and IP of the Encoder/Decoder

can be found.)

First, connect the computer to the LAN port of the receiver;

Then enter the device’s WiFi IP (wireless transmission module IP) in the

address bar to enter the login page:

After successful login, enter the WiFi board parameter page of the device:

Enter username: admin

Enter password: admin

192.168.1.201, 192.168.1.202, 192.168.1.203, 192.168.1.204

Encoder IP

192.168.1.111, 192.168.1.112, 192.168.1.113, 192.168.1.114

192.168.1.100

Receiver

192.168.1.211，192.168.1.212，192.168.1.213，192.168.1.214

Transmitter

Wireless

transmission

module IP

(WiFi IP)

Decoder IP

Wireless

transmission

module IP

(WiFi IP)

Each transmitter has one wireless transmission module, and the software

upgrading needs to be implemented on each transmitter. Receiver also has

one wireless transmission module, and the software upgrading needs to be

implemented on it accordingly.

Information label on transmitter: