User Manual

19
20
Encoder/Decoder Configuration and Upgrading
Receiver module: (Since the receiver has four decoders, there are four
corresponding IP addresses need to be configured)
Version:CM3060V3.15
IP ETHADDR
192.168.1.212
GROUP
2222
LATENCY_MODE
1
Serial Baud Rate
2400 9600 19200 38400 57600 115200
File Upload:
选择文件
未选择任何文件
(Select A Local File)
Save the configuration and then reboot...
Save Environment
1
2
Software version
Decoder IP address (192.168.1.211~214)
Corresponding transmitter ID (1111/2222/3333/4444)
Serial baud rate
Software upgrade:
① Select the file to be upgraded
② Click Save to complete the upgrade
Standard Mode Bitrate
8000
Range(1000-25000)
RTSP Bitrate
Range(1000-15000)
SDI Audio Mode
0
1
Serial Baud Rate
2400 9600 19200 38400 57600 115200
File Upload:
选择文件
未选择任何文件
(Select A Local File)
Save the configuration and then reboot...
Save Environment
1
2
Transmission bitrate
RTSP streaming bitrate
Serial baud rate
Software upgrade: ① Select a file; ② Click Save
IP ETHADDR
192.168.1.112
GROUP
2222
Transmitter Encoder Case (transmitter 2):
Transmitter IP address(192.168.1.111~114). Do not change the IP,
otherwise the wireless connection will be shut down.
Transmitter ID (four devices correspond to 1111, 2222,
3333 and 4444, respectively), Do not change the ID, otherwise the wireless
connection will be shut down
Keep the computer connected to the receiver through LAN port,
and keep the receiver connected with all transmitters normally.
Open internet browser, and enter transmitter’s encoder or receiver’s
decoder IP address in the address bar to enter the parameter settings page.
All transmitter’s encoder and receiver’s need to be configured
one by one, please refer to the following configuration case.
decoders
Receiver Decoder Case (Decoder 2):
192.168.1.201, 192.168.1.202, 192.168.1.203, 192.168.1.204
Encoder IP
192.168.1.111, 192.168.1.112, 192.168.1.113, 192.168.1.114
192.168.1.100
Receiver
192.168.1.211，192.168.1.212，192.168.1.213，192.168.1.214
Transmitter
Wireless
transmission
module IP
(WiFi IP)
Decoder IP
Wireless
transmission
module IP
(WiFi IP)
Each transmitter has one encoder, and its configuration and software
upgrading need to be implemented on its encoder . Since the receiver has
four decoders, the configuration and software upgrading need to be
implemented on its each decoder respectively.
Each transmitter has one wireless transmission module and one encoder.
Receiver has one wireless transmission module and four decoders.
All modules and each encoder/decoder have their respective IP address as
follows, and all configuration and upgrading operation must be
implemented under its own IP address.