User manual

Open
Figure 50
After installation of
the POU Assembly,
the Reset indicator
sho u ld be loca ted
towards the rear of
the cooler
SLIDE TO RESET
Standup Series Bracket Installation Instructions
INSTALLATION
1.Remove the two mounting screws that
secure the Bottom Plate to the outer
enclosure.
2.While holding the "S" shaped bracket
against the cooler (refer to diagram)
r e in s ta ll a n d ti gh t en t h e b o tt o m
plate/outer enclosure screws securely.
3.Place the cooler in position against the
wall and using the "S" bracket, mark the
location of the wall insert holes to be
drilled (if required). If not required,
secure the cooler to the wall using the
two screws provided.
Figure 51
Screw
Condenser
Bottom Plate
"S" Mounting Bracket
CLEANING
Do Not Immerse the Unit in Water for Cleaning
Remove any dust or contaminants from the cooler by rinsing the cold water reservoir and faucets with clean water
prior to use (Figure 38 and Figure 39). Use only mild dishwashing liquid detergent for cleaning the exterior
surfaces. DO NOT USE bleach or abrasive cleaners.
Figure 38 Figure 39
Parts may not appear exactly as shown
(Figure 50)