User manual

R, P & G Series
On Cook & Cold and Hot & Cold models the reservoir can be removed easily by following the steps given below.
1. Unplug and approach the cooler from the front (Figure 27)
2. Turn off the water supply via the shut off valve, and disconnect the water supply from the cooler. (Figure 28)
3. Remove the POU Cover (if installed) (Figure 29) Use the fingertips of both hands to press on the POU Lid
Assembly and turn counter clockwise till it is free from the cooler opening. (Figure 30, Figure 31) Lift off of
the cooler, and set aside. Drain the water from the reservoir and hot tank (Figure 32), remembering to cool
and drain hot tank. Allow 1 hour for hot water to cool down.
4. Using fingers of both hands, loosen and remove the insulation jacked covering the plastic reservoir from the
cooler opening (Figure 33). (Note: On Hot & Cold models, after step 4 unscrew the round plastic one piece
baffle) (Figure 34)
5. Approach the cooler from the rear and open the latch provided on the evaporator band (Figure 35)
Figure 27 Figure 28
Figure 32Figure 29 Figure 30 Figure 31
Figure 33 Figure 34
Figure 35
6. Remove the faucets from the reservoir elbows by turning them counter-clockwise (Figure 36)
7. Use both hands, loosen the reservoir from the evaporator band and lift it straight through the cooler
opening (Figure 37)
Figure 37Figure 36