User manual

3. Remove the POU Cover (if installed) (Figure 16) Use the fingertips of both hands to press on the POU Lid
Assembly and turn counter clockwise till it is free from the cooler opening. (Figure 17 and Figure 18) Lift
off of the cooler, and set aside. Drain the water from the reservoir and hot tank (Figure 19), remembering to
cool and drain hot tank. Allow 1 hour for hot water to cool down.
4. Using fingers of both hands to lift up and remove the insulation jacket covering the reservoir, from the cooler
opening (Figure 20 and Figure 21)
5. Remove the baffle cup by lifting straight out (Figure 22). Loosen & remove the baffle stem and wing nut by
turning counter-clockwise (Figure 23 and Figure 24).
6. Approach the cooler from the rear and open the latch provided on the evaporator band (Figure 25)
7. Use both hands, loosen the reservoir from the evaporator band and lift it straight through the cooler opening
(Figure 26)
Figure 16 Figure 17 Figure 18 Figure 19
Figure 21Figure 20
Figure 22
Figure 23 Figure 24
Figure 25 Figure 26