User manual

5. Ensure the following when cooler is to be serviced:
5.1 Turn off Hot Tank Switch (Hot & Cold models only) and disconnect power supply cord (Figure 7 to Figure 8).
5.2 Turn off the water supply via the shut off valve, and disconnect the water supply from the cooler (Figure 9).
5.3 Use a bucket to drain water from the cold water reservoir through faucets (Figure 10). On Hot & Cold models,
turn off hot tank switch as above (Figure 11). Allow 1 hour for the hot water to cool down inside the hot water
tank. Remove the drain plug at the rear of the cooler to drain into a container (Figure 12 and Figure 13).
CAUTION! ALWAYS DRAIN WATER COMPLETELY
BEFORE SHIPPING OR STORING THE COOLER!
Figure 7 Figure 8 Figure 9
Figure 10 Figure 11 Figure 12 Figure 13
4. Do not draw water from the cooler for about 30 minutes to let the water cool or heat. Optimum water temperatures
will be reached after several hours of operation (Figure 5 and Figure 6).
Figure 5 Figure 6
Reservoir Removal (E&S Series)
On Cook & Cold and Hot & Cold models the reservoir can be removed easily by following the steps given below.
1. Unplug and approach the cooler from the front (Figure 14).
2. Turn off the water supply via the shut off valve, and disconnect the water supply from the cooler. (Figure 15)
Figure 14 Figure 15