Specifications

Technology Upgrade Classroom Video 28 5300-2
1224_01
B. Video projector Short Throw with Interactive image.
1. The video projector shall have a minimum of 3300 ANSI lumens of light.
2. Native Aspect Ration of 16:10, Image native resolution of WXGA (1280x800) and
shall resize UXGA, SXGA, SVGA, and VGA signals.
3. The projector shall also support NTSC, PAL, SECAM, PAL/M, PAL/N.
4. The unit shall have the following inputs/outputs as a minimum:
a. Video inputs, HD-15, RCA Composite, HDMI
b. Audio in: 3.5mm x 2
c. Audio Line level output, 3.5mm
d. USB for control and interactive connectivity.
5. Third party projector control shall be via an on-board RS-232 connection or LAN
Connection.
6. The projector shall be HDTV ready, and shall support 480I, 480p, 720p, and 1080i
formats.
7. Keystone correction shall be a minimum of 5 degrees.
8. Each projector shall be supplied with a remote control.
9. Projector shall be Epson Brightlink #585Wi
10. Spare Bulbs. The contractor shall provide a spare projector bulb for each of the
projectors installed as part of this project.
11. Provide full interactive software and one interactive pen with each projector.
Contractor shall load the software on each classroom PC and shall setup each
projector by setting screen and interactive parameters on the markerboard.
C. Video Mounts (Supports):
1. All supports for LCD panels, Projectors and monitors shall be appropriately sized and
chosen for the exact model display to be supported.
2. Contractor shall match the weight of the display to the recommended weight rating of
the support.
3. Contractor shall review the location where the support is to be mounted. Match the
surface to which the display is to be mounted with the best attachment hardware
available for the support.
4. All projector mounts shall be Chief Mfg. #RSMAU series or equal. Contractor shall
submit each support for review by the Owner and Engineer prior to installation.
5. Ceiling mount for projectors shall be Chief #CMS-440 or equal. Install custom length
down pipe and attach to projector mount.
6. The video mount shall be utilized for all projectors except for certain short throw
projectors. Short Throw projector mounts shall be Epson # ELPMSTPW or equal.
7. Where drop ceiling is not installed, contractor shall provide a connection to the
building structure and custom length downpipe for mounting projector.
a. Mount shall allow cables to be routed through the pipe.
2.03 VIDEO EQUIPMENT
A. Document Camera.
1. Shall be USB attached or HDMI attached.
2. Shall have minimum resolution of 5.0 MegaPixel HD CMOS
3. 1x LED light
4. 15ft USB pr HDMI cable,
5. Hovercam Solo 5 or equal
B. USB via UTP extender.
1. Extender shall transmit USB signals via standard CAT-6 UTP cable.
2. Unit shall sit at the PC and at the projector for transitioning from Interactive White
Board or Projector to the PC.
3. Provide USB patch cables at each end.
4. Unit shall allow extension of the USB signal up to 100’.
5. Units shall be self powered/bus powered.