Specifications

Technology Upgrade Security Recording 28 3600-9
1224_01
1) Sit with the owner and review each cameras view and custom set the
aiming, framing and focus of each camera.
i. Generation of custom views for all user software. Meet with each person that is
allowed to view the cameras and help them generate a custom view of the
cameras they wish to see.
9. Contractor shall fully load and match all maps to the video security system. Install all
maps and load all camera locations and hot buttons to the maps to allow quick
connect to the cameras based on clicking on the camera location on the map.
a. Each camera button shall show the camera number.
10. Recorded images and offloaded images shall be able to be time-stamped with the
date, camera number and exact time down to the second when the video was
recorded.
a. This shall be able to be seen on the viewing station and shall be attached to
the video when it is offloaded and viewed on an outside player.
b. Setup the server and software to obtain time from the national standard time.
C. Connect the storage to the new NVR servers and the rest of the servers.
1. Configure the storage to provide service to all users and all storage requirements.
2. Meet with the owner prior to installation and present all options to the owner in
regards to the configuration options. Assist the owner in deciding which options best
meet their needs.
3. Publish a plan and configuration parameters of the storage and ensure that everyone
agrees with the plan.
4. Install the storage and connect to all servers.
D. Ethernet systems configuration shall be coordinated with the IT department. The owner will
work with their contractor to switch the network to a security VLAN and other QOS
parameters as required by the security system.
1. Meetings shall be scheduled with the Owner to discuss the configurations of all
electronics and the capabilities of the system.
2. The owner shall be made aware of all the capabilities of the video security system
and all possible configurations and shall be able to decide all aspects of the
programming and configuration.
3. The Contractor shall generate a report on the requirements of the owner and shall
work with the owner to help determine the configuration of all the data electronics to
meet the security systems needs.
4. From the meetings the owner and contractor shall generate a plan for all
configuration issues of the data network including but not limited to:
a. IP Numbering Scheme
b. VLAN settings
c. Quality of Service (QoS) settings
d. Network Prioritization
e. New data connections.
f. Wireless connectivity for Visitors, Students and Administrators.
g. Wireless Security
5. The network electronics shall be configured to synchronize internal clocks to a
designated internal NTP server.
6. The network electronics shall be configured with the same time zone settings and
said time zone shall be the local time zone.
E. LCD Displays:
END OF SECTION