Specifications

Technology Upgrade Cat-6 Cabling 28 1600-5
1224_01
1.5
SC Angled
IM1SCA15OW
2
Two SC Angled
IM2SCA2OW
E. Some locations will require custom stainless steel plates. These shall be configured with the
correct connectors and pass thru’s to support all the data, audio and video.
1. All shall be silk-screened to detail what each connector is for.
2. Submit a product sheet for approval prior to purchase of the plates.
F. Wall mount phone plates shall be stainless steel.
1. Each plate shall be equipped with a CAT-3, 8 port modular jack.
2. Each plate shall be equipped with stainless steel studs for mounting a wall mount
telephone to the plate.
3. Single gang wall mount phone plate shall be Hubbell # P630S1GJ8.
G. In addition to flush faceplates and surface housings, some installations call for integrated
furniture outlets, GFI style outlets, and standard 106 style frames. These may be required at
some surface raceway location. Field verify prior to ordering.
1. The Contractors shall identify which type of outlet or frame is required at each
location throughout the system.
2. Match the particular outlet with the faceplate required.
3. GFI, more commonly referred to as style line outlets, are rectangular and fit in a
rectangular plate used for GFI receptacles.
4. Each type of modular furniture has certain requirements for its voice and data
modules. The Contractor shall coordinate with the furniture installer and provide the
correct faceplate and outlets to match the color and style of the furniture.
5. The 106 style frame fits in a common duplex electrical receptacle faceplate. The
frame holds 2 or 4 modular jacks.
6. For all connections that do not have a faceplate with a location for a laser printed
paper label, the Contractor shall provide an engraved lamacoid label detailing the
location number of each cable.
7. GFI Plates shall be:
a. Hubbell # ISF2OW, ISF3OW, ISF4OW or ISF6OW or equal.
8. 106 style plates shall be
b. Hubbell # BR106C or Q106 or equal.
9. Style Line plates shall be:
c. Two-port, Hubbell #ISF2OW
d. Three Port, Hubbell #ISF3GY
e. Four Port, Hubbell #ISF4W
H. Provide surface mount boxes for termination of cables as shown on the drawings.
1. Install a surface mount box at location for termination of the CAT-6 jack.
2. Single cable surface box shall be Hubbell #ISM1OW.
3. Multiple cable surface box shall be Hubbell #ISM40W.
I. All cables shall be supported in the ceiling a minimum of every 5 feet. Support can be
provided by installing cable inside cable tray or conduit, or by installing J-hooks every 5 feet.
1. J-hooks shall provide a smooth steel support for cables as they route through the
ceiling.
2. each hook shall have a galvanized finish.
3. Steel, UL listed, ultimate static load limit 50 pounds rated to support Category 3 and
higher cables, and optical fiber cables.
4. If required, assemble to manufacturer recommended specialty fasteners, including
beam clips and flange clips.
5. Acceptable products shall be by CADDY, and shall be the CableCat series of
6. J-hooks.
7. Provide Caddy No. CAT12 (3/4 loop and up to 16 UTP 4 pair or 2 strand fiber optic
cables) or Caddy No. CAT21 (1-5/16 loop and up to 50 UTP 4 pair or 2 strand fiber
optic cables or 1 innerduct);