Specifications

Technology Upgrade Warranty 28 7800-2
1224_01
1. Spare parts may include, but not limited to: blank covers for electronics, supports
and mounting hardware.
C. The contractor shall provide two copies of the as-built prints.
1. They shall be a clean set of the latest drawings with red lines marked for all field
changes or bulletins.
2. Changes to be reflected on the drawings for Security Systems shall include:
a. Changes shall include all camera locations
b. Include any changes to hardware installed at each door.
c. Changes to the panel locations
d. Camera numbers and door numbers
e. Changes to the schematic connectivity of any system shown on the drawings.
3. Changes to be reflected on the drawings for Audio and Video Systems shall include:
a. Microphone/speaker faceplate locations and labels.
b. Rack/cabinet locations.
c. Speaker and microphone locations.
d. Rack layout of all components in each rack.
e. Changes to the schematic connectivity of any system shown on the drawings.
f. Ceiling/wall mounted projector locations
g. Label designation of all cables, including system interconnection cables.
4. Changes to be reflected on the drawings for Cabling Systems shall include:
a. Route of exterior conduits and exterior cabling
b. Rack/cabinet locations.
c. Faceplate locations
d. Rack layout of all components in each rack.
e. Changes to the schematic connectivity of any system shown on the drawings.
f. Cable numbering for each faceplate.
D. Test results shall be supplied and submitted. Submit in hard and soft copy for all cable tests.
Include software to read the test results
E. The manufacturer of all electronics provides a warranty on their product. The extent of that
warranty is spelled out on cards provided in the box for each piece of equipment. These
cards or pamphlets shall be provided to the Owner.
3.04 GENERAL WARRANTY
A. The Contractor shall warranty the installation and all the parts contained therein for a period
of not less than 1 year after receipt of a completely signed copy of the Notice of Substantial
Completion.
B. This shall include each and every part, cable or software system provided as part of this
project. This includes cabling, Audio/Video systems and Access Control and Video Security
systems.
1. If any part is broken due to a manufacturing defect or installation defect, the
Contractor shall fix and/or replace the broken item at their own expense.
2. The Contractor shall also supply all configuration and programming necessary to
keep all electronic equipment to the latest revision of software during the year.
3. If the “system” goes down, and needs configuration to be brought back up, the
Contractor shall be liable for any programming or reconfiguration.
4. During the year, the Contractor shall make the Owner aware of any software
upgrades that are available.
5. Contractor shall install all software upgrades for that year or as detailed below for
specific systems.
3.05 EXTENDED CABLING WARRANTY
A. The Contractor shall provide to the Owner a “Link Warranty” on all the components of the
voice/data cabling system. This includes all components from the faceplate, through the
jacks, cable, and back to the patch panels, not including patch cords.