Specifications

Technology Upgrade Labeling 28 7600-2
1224_01
3. Size the phenolic labels for their individual uses. Provide a sample to the Engineer for
approval prior to ordering or installation.
F. Cameras shall be labeled with the camera number in a visible location.
1. Affix a label to the camera housing that details the camera number
2. Shall be in a location that is visible from a standing position.
3. Shall be laser printed.
G. Wireless access points shall have a label affixed in a visible location on the front of the
access point. This shall include all Access Points.
1. The label shall identify the AP name and IP address.
2. All labels shall be machine printed.
H. Ethernet Switches
1. Each switch installed shall be equipped with a label on the back or top that includes:
a. Switch name as shown in the management platform
b. IP address
c. Date of install
PART 3 - EXECUTION
3.01 PREPARATION
A. Terminate all cables in proper color code sequence.
B. Clean any surfaces where an adhesive label is to be installed.
C. Prior to beginning the work, the contractor shall submit to the engineer a plan for labeling all
the cables. This shall take into account to what components each cable is connected.
3.02 EXECUTION
A. The Contractor shall make up a spreadsheet listing each audio and video cable that extends
from the cabinet/rack to a location within the building.
1. The spreadsheet shall detail the number of the cable, the room it is located in, and
the cabinet to which it routes.
2. One line on the sheet shall show the results of the test. After being tested for
continuity, and being tested that the cable delivers the required signal, the Contractor
shall enter “PASS” into the result column.
3. There shall be spaces for the name of the person doing the test, the date, and the
company name.
4. All information on the sheet shall be printed by a printer except the name of the
person performing the tests, the date, and the “PASS” column.
5. This spreadsheet shall be submitted to the Engineer and Owner prior to project
completion.
B. Each coax, control, video, speaker, and microphone cable shall be labeled with a self-
laminating, laser printed label at each end. This includes all interconnection cables.
1. The cables shall be labeled for the equipment that the cable connects . Consult with
the Engineer prior to labeling.
2. All speaker cables shall be marked according to their location in each room. Consult
with the Engineer prior to labeling.
3. Each video cable shall be labeled according to the equipment it connects to.
4. The cable label shall be similar to the label below:
SPKR-1
SPKR-1
SPKR-1