Specifications

Technology Upgrade Wireless 28 6250-1
1224_01
SECTION 28 6250 – WIRELESS
Renumbered = Yes
Updated = Yes
PART 1 - GENERAL
1.01 SECTION INCLUDES
A. Parts, equipment and configuration required for wireless data network electronics.
1.02 SYSTEM DESCRIPTION
A. The wireless network and all of its components shall be installed so that access is provided
to all components for general maintenance and repair.
B. The owner wishes to install a wireless data network to serve wireless devices throughout the
building.
1. The contractor shall provide and configure all the equipment required for connecting
the wireless network throughout the building.
2. Provide a wireless network controller that can manage and configure the radios
throughout the system. The controller may be centrally located or located in the radio
itself. Software shall be provided for central management of the system.
3. The wireless network shall be configured to allow students and staff connectivity to
the network while allowing visitors access to the internet. Provide separate logons
and separate rules for each type of user
C. Complete a site visit and wireless audit of the buildings prior to installation to maximize
wireless access point locations.
1. Software estimation of the WAP locations is sufficient prior to installation.
D. Contractor shall place access points at locations that will allow maximum coverage of the
space. Contractor shall test connectivity on-site after installation.
E. Contractor shall configure the network and wireless system with strict authentication/access
codes based on the owners input for user rights.
1.03 COORDINATION
A. Coordinate the location of the data network electronics with the Engineer and Owner as per
the detailed drawings.
B. Coordinate the configuration of the data network electronics for compatibility with WAN
connections, addressing and routing.
C. Work with the cabling contractor to direct them in the actual location of the cables to be
terminated and coiled
PART 2 - GENERAL
2.01 MANUFACTURED PRODUCT
A. Manufacturer of the wireless data network shall have been manufacturing data products for
no less than 3 years and shall have a record of providing high-quality equipment.
B. System shall be in current manufacture and shall not be scheduled for end of life within the
period of support.
C. The availability of support shall be guaranteed by the manufacturer for a period of no less
than 5 years.
D. All components of the system shall be newly manufactured products. Remanufactured,
refurbished or show floor equipment is not permissible.
E. Each component of the wireless network shall adhere to all ANSI, IEEE, EIA/TIA, ISO,
NFPA, and NEC articles and standards that may apply.
F. The system shall be installed with the latest revision of all hardware, firmware and software
supported by the manufacturer; as of the final completion date of this project.
G. The system shall be installed to support -67dB coverage throughout the buildings in the
5Ghz Band