Specifications

Technology Upgrade Audio Equipment 28 5450-3
1224_01
b. Parametric bandpass, all-pass, high & low shelf & cut filters.
c. Feedback elimination.
d. Graphic equalization with Perfect-Q™ response.
e. Linkwitz-Riley, Butterworth, Bessel crossovers.
f. Compression, limiting, Automatic Gain Control (AGC).
g. Mix, select, level control, delay.
h. Pink noise and sine wave generators.
4. Control ports shall include 8 logic inputs for contact closure preset recall or
potentiometer level control.
5. All processing settings shall always be stored in nonvolatile memory within the unit,
thus allowing for power or computer failure without loss of settings.
6. Data conversion shall be 24-bit, 48 kHz sampling rate using up to 48-bit internal DSP
processing with a minimum 104 dB dynamic range.
7. The two-channel DSP unit shall be a Rane #RPM 22 or equal.
8. Equip with a remote volume control, Rane #VR2.
2.04 AUDIO DEVICES
A. Provide and install Line Level Audio Distribution Amplifier.
1. RDL Labs #ST-DA3
2. Equip with power supply, RD Labs #PS-24AS
B. Handheld Portable Recorder shall include:
1. Built-in Stereo Condenser Omnidirectional Microphones with sensitivity up to 125dB
SPL
2. Stereo MP3 recording from 32-320 kbps bit rate
3. 1/8” stereo mic/line input. Line Level audio input.
4. Limiter and low-cut filter to help prevent distortion
5. Automatic or manual level setting
6. Loop and repeat playback
7. Up to 99 mark points on each file
8. USB 2.0 port for transfer to PC and external power
9. Up to 2-second pre recording buffer
10. Jump back function returns to previous point with one action (1-10, 20, 30 sec.)
11. 1/8” headphone/line output
12. Built-in speaker
13. Slots for microSD (64MB – 2GB)/microSDHC (4GB – 32GB) card slot. Equip with a 4
Gig memory card.
14. Powered by 2 AA batteries or AC adapter. Provide a power supply.
15. Recorder shall be Tascam #DR-05
2.05 WIRELESS MICROPHONES
A. Wireless Microphone Kits:
1. Headworn wireless microphone shall consist of:
a. (1) Body-Pack Transmitter with two batteries
b. (1) Single Rack Mounting Kits.
c. (1) Diversity Receiver with 193 selectable frequencies
d. (1) Zippered Transmitter/Accessory Bag.
e. (1) HT2P Professional headworn Microphone with Supercardiod capsule
f. Shall be Audix #W3HT2 or equal.
2. Handheld wireless microphone. It shall consist of:
a. (1) handheld Mic with two batteries
b. (1) Single Rack Mounting Kits.
c. (1) Diversity Receiver with 193 selectable frequencies
d. (1) Zippered Transmitter/Accessory Bag.
e. (1) W3 Professional handheld Microphone