Technical data

ISSUE 2

SERVICING NOTES

GENERAL NOTES.

SERVICING SHOULD BE CARRIED OUT ANNUALLY BY A COMPETENT PERSON SUCH AS

A CORGI REGISTERED PERSON IN ACCORDANCE WITH THE RELEVANT REGULATIONS,

TO ENSURE THE SAFE AND CORRECT OPERATION OF THE APPLIANCE

BEFORE COMMENING ANY SERVICE OR REPLACEMENT OF PARTS TURN OFF GAS

SUPPLY TO FIRE

AFTER SERVICING CHECK FOR GAS SOUNDNESS

AT LEAST ONCE A YEAR CHECK FOR DEBRIS

IF SOOT HAS ACCUMULATED CHECK TO ESTABLISH CAUSE AND RECTIFY IF

NECESSARY CLEAN FLUE OR CHIMNEY ACCORDINGLY

EXAMINE THE FUEL FOR SIGNS OF CRACKING AND REPLACE IF NECESSARY. SEE

FUEL LAYOUT PROCEDURE BEFORE ATTEMPTING TO REPLACE FUEL WHICH SHOULD

ONLY BE REPLACED AS A COMPLETE SET WITH NO EXTRA FUEL ADDED.

1 REMOVAL OF FUEL PIECES

REMOVE LOOSE FUEL PIECES

REMOVE FRONT FIBRE BASE

REMOVE MAIN FIBRE BASE

2 REPLACEMENT OF GAS CONTROL

REMOVE FUEL SET AS 1

DISCONNECT FIRE AT INLET ELBOW

REMOVE FIRETRAY BY UNSCREWING TWO SCREWS AT FRONT BOTTOM

SECTION OF FIRE TRAY

REMOVE CONTRO KNOB,DISCONNECT GAS CONNECTIONS TO VALVE

INCLUDING PILOT CONNECTION AND THERMOCOUPLE CONNECTION

REMOVE LOCKNUT HOLDING GAS CONTROL TO FRONT BOTTOM

SECTION .

RE ASSEMBLE IN REVERSE ORDER

TURN ON GAS SUPPLY.CHECK FOR SOUNDNESS AND RE COMMISION

APLIANCE

3 REPLACEMENT OF INJECTOR

REMOVE FUEL PIECES SEE 1

REPEAT 2 REMOVE GAS CONTROL

DISCONNECT GAS CONNECTION TO INJECTOR

UNSCREW INJECTOR “B” WHILST AT THE SAME TIME HOLDING

LOCKNUT WITH A SPANNER AND CLEAN OR REPLACE.

SEE DIAGRAM BELOW.