Technical data

20 issue 5
Fitting the Bark Chips
Carefully place some of each colour of the Bark
Chips on top of the Vermiculite Chips.
Finally strategically place one or two pieces of each colour
of Bark Chips onto the Burner Ceramic Base Pad
between the Logs where they will be seen as shown in Fig
18:9
Important do not place any pieces
Directly in front of the Pilot.
Finally ensuring the Pilot is visible and clear of any
Vermiculite and/or Bark Chips.
Check that the Glass Door is clean then seal closed with
the 2 screws
Fig 18:9
19. PEBBLE SET
The log support bracket must be removed
before the pebbles can be installed by removing
3 self tapping screws and lifting away the
bracket
Keep bracket and screws safe if for any reason
you may wish to return to the log set up in the
future
The fibre base is factory installed ,
however the rear fibre strip has to be
positioned as right .
Ensure it is pushed up to lip of tray
(ensure it does not cover the
aeration hole behind the fibre
base shown )
Fibre base