Service manual

174
VSX-49TX, VSX-47TX
Display (VSX-49TX)
All the display information is explained and /or referenced here.
DIGITAL
PRO LOGIC
2ch PLAYBACK
MPEG
DISC MTRX
Neo :6
OVER ATT
RDS
RF ATT
TUNED STEREO MONO
SP
A
B
L
LFE
TAPE2
CR
L S SR S
3
ENO
SIGNAL
AUTO
RF
DIGITAL
ANALOG
1 2 5 63 4
789
6 Digital format indicators
2 DIGITAL : Lights when a Dolby Digital signal is
detected.
DTS: Lights when a DTS signal is detected.
MPEG: Lights when an MPEG signal is detected.
THX: Lights when the HOME THX mode is
selected.
EX: Lights during Surround EX matrix processing.
ES: Lights when a decoding DTS ES audio.
DISC: Lights during DTS ES discrete processing
MTRX: Lights during DTS ES matrix processing
2 PRO LOGIC II : Lights during Dolby Pro Logic
II processing.
NEO:6: Lights during NEO:6 processing.
2CH PLAYBACK Lights during two-channel
playback.
7 Speaker indicators
Light to indicate the current speaker system, A
and/or B.
8 TAPE 2 indicator
Lights when the TAPE 2 monitor is on.
9 TUNER indicators
MONO : Lights when the tuner is set to receive
FM broadcasts and when selected MPX mode.
STEREO : Lights when a FM stereo broadcast
is received in the auto stereo mode.
TUNED : Lights when a broadcast is received.
1 SIGNAL SELECT indicators
Light to indicate the input signal you selected.
ANALOG : Lights when an analog signal is
selected.
DIGITAL : Lights when a digital signal is selected.
2RF : Lights when an 2 RF signal is selected.
AUTO : Lights when the receiver is set to select
the input signal automatically.
2 Program Format indicators
For Dolby Digital or DTS sources : These
indicators change according to which channels
are active in the source. When all three LS (left
surround), S (surround) and RS (right surround)
light at the same time it means a source with a
6.1ch playback flag is being used.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel (mono).
RS – Right surround channel.
LFE – Low frequency effects channel.
3 ((( ))) – Lights when LFE signal is input.
4 Analog level indicators
OVER – This lights if the signal is in danger of
distorting for analog source signals. Press
INPUT ATT on the front panel to lower the
signal level.
ATT – Lights when INPUT ATT is used to
reduce the level of the analog source signal.
5 Character display
Shows current mode, status, etc.