User manual

4. Installation

You should install the receiver when powering on your product for the first time after

purchase.

Tip: The default password is 0000. If you have forgotten your password, please

contact your local product distributor.

4.1 Powering On

1. Connect the power cord of the product to a wall outlet.

2. Ensure the ON/OFF switch at the rear of the product is switched to ON.

3. Power on by pressing the STANDBY button on the remote control or the

STANDBY button at the front of the product.

4.2 Manual search

Manual Search allows you to configure the cable setting parameters.

Menu-> INTALLATION ->Manual Search

Here you can Search channels, Edit, Add and Delete transponder.

 Start Search

Select the frequency that you want to search, please make sure the signal of this

frequency is good enough, press OK button as sign and then press RED button to

start search the channels on your selected frequency. When searching finished, TV

channels and Radio channels will be listed separately.