Installation guide

WF200 802.11g Wireless Router

z Web-based GUI Configuration / Management

z Command-line Interpreter (CLI)

z SNMP support (V.1 and V.2C)

z Telnet Remote Management

z Firmware upgrade via FTP / TFTP (Web-based GUI)

z Built-in Diagnostic tool

z TR-069 support (CPE WAN Management Protocol)

 10/100M Auto-negotiation Fast Ethernet switch

This auto-negotiation feature allows the router to detect the speed of incoming transmissions and adjust

appropriately without manual intervention. It allows data transfer of either 10 Mbps or 100 Mbps in

either half-duplex or full-duplex mode depending on your Ethernet network.

 Bridging / Routing support

z Ethernet to ADSL self-learning Transparent Bridging (IEEE 802.1D)

z IP routing-RIPv2 (backward compatible with RIPv1)

z Static IP routing

z Routing (TCP/IP/UDP/ARP/ICMP)

z IP Multicast IGMP v1/v2

 Wireless

z IEEE802.11g compliance, backward compatible with 802.11b (at 11Mbps)

z 64/128-bit WEP, WPA, WPA2 security

z Dynamic date rate scaling at 54, 48, 36, 24, 18, 12, 9 and 6Mbps for

IEEE802.11g

z Dynamic date rate scaling at 11, 5.5, 2 and 1Mbps for IEEE802.11b

z Supports Quality of Service (QoS), 802.11e, WMM

z MAC Address Filtering

 Security

z PPP over PAP (Password Authentication Protocol; RFC1334)

z PPP over CHAP (Challenge Authentication Protocol; RFC1994)

z DoS Protection

z Stateful Packet Inspection (SPI)

z VPN (IPSec, PPTP, L2TP) pass through

z Built-in NAT Firewall

z IP-based Packet filtering

z Password Protected System Management

2. Hardware Installation

2.1 System Requirements

z Pentium III 266 MHz processor or higher

z 128 MB RAM minimum

z 20 MB of free disk space minimum