Installation guide

WF200 802.11g Wireless Router
46
allowed
Protocol: Select the protocol to filter. Choices are TCP, UDP, and ICMP.
Rule Unmatched: Choices are Forward and Next. Select what happens to the data in question if the
rule you are currently editing is unmatched. Next means that the data is then compared to the next IP
filter rule. Forward means that the data will be allowed into your system. Note that a Forward rule
should be the last rule, as no data will be compared to rules after a Forward rule.
IP/MAC Filter Set Index: Select the IP/MAC filter set you wish to view.
For Example
Please follow below steps to set your IP Filter:
1. IP/MAC Filter Set Editing: Choose your IP/MAC Filter Set Index, Interface and Direction
options. Remember, Interface and Direction functions are affected with IP/MAC Filter Set Index
.
EX: if your 1
st
index set of IP filter set PVC0 as Interface and Outgoing as Direction, so the list of
1
st
IP Filter will be PVC0 and Outgoing as their settings.
2. IP/MAC Filter Rule Editing: Select the IP/MAC Filter Rule Index (up to 6 numbers for each
set index) and choose Active option. As below example, Source IP Address is 192.168.1.4,
Subnet Mask is 255.255.255.255, Destination IP Address & Subnet Mask is 0.0.0.0, Port
Number is 80, and, Protocol sets TCP. From this setting, it filters 192.168.1.4, so it cannot access
the web. Notice, each IP Filter Set Index can have up to 6 filters IP. At “Rule Unmatched” option,
you must choose NEXT until the last filter IP choose Forward.
3. After every setting is done, click SAVE to continue next IP Filter Editing.