Installation guide

WF200 802.11g Wireless Router
39
with single IP will use the same Virtual Server rules.
Start & End port number: Enter the specific Start and End Port number you want to forward. If it is
one port only, you can enter the End port number the same as Start port number. For example, set the
FTP Virtual server, you can set the start and end port number to 21.
Local IP Address: Enter the IP Address for the Virtual Server in LAN side.
Virtual Server Listing: This is a listing of all virtual servers your have set.
When you are done making changes, click on SAVE to save your changes, DELETE to delete the rule
with the parameters you set, BACK to return to the previous screen or CANCEL to exit without
saving.
6.3.7 IP Address Mapping
The IP Address Mapping is for those VCs that with multiple IPs. The IP Address Mapping rule is per-
VC based. (only for Multiple IPs’ VCs).
Rule Index: The Virtual server rule index for this VC. You can specify up to 10 rules. All the VCs
with single IP will use the same Virtual Server rules.
Rule Type: There are 4 types of One-to-One, Many-to-One, Many-to-Many Overload, and Many-to
Many No-Overload.
Local Start & End IP: Enter the local IP address you plan to map to. Local Start IP is the starting
local IP address & Local End IP is the ending local IP address. If the rule is for all local IPs, then the
Start IP is 0.0.0.0 and the End IP is 255.255.255.255.
Public Start & End IP: Enter the Public IP Address you want to do NAT. Public Start IP is the
starting Public IP Address and Public End IP is the ending Public IP Address. If you have a Dynamic
IP, enter 0.0.0.0 as the Public Start IP.
When you are done making changes, click on SAVE to save your changes, DELETE to delete the rule
with the parameters you set, BACK to return to the previous screen or CANCEL to exit without
saving.