Installation guide

WF200 802.11g Wireless Router
27
the fields must be in the appropriate IP form, which is 4 IP octets separated by a dot (x.x.x.x). The
Router will not accept the IP address if it is not in this format.
The following table describes the labels in this screen.
LABEL DESCRIPTION
Encapsulation Select your encapsulation type from the dropdown list.
Static IP Address Enter the static IP Address here.
IP Subnet Mask Enter the IP Subnet Mask here.
Gateway Enter the Gateway address here.
NAT Select whether NAT is Enabled or Disabled.
Default Route Select whether this PVC will be the default route for Internet data.
TCP MTU Option Enter TCP MTU Value here
Dynamic Route Select the RIP type and direction from the dropdown lists.
Multicast Select the multicast protocol you wish to use from the dropdown list.
(3) PPPoA / PPPoE
Select this option if your ISP requires you to use a PPPoE connection. This option is typically used for
DSL service. Select Dynamic PPPoE to obtain an IP address automatically for your PPPoE connection.
Selection Static PPPoE to use static IP address for your PPPoE connection. Please enter the information
accordingly.