Installation Manual

Cryptera A/S SV/INT3520-2000-10 rev.B Page 12 of 22
Installation Manual
4.5 Environment – Operating and Storage
The following sections define the environmental conditions for the NFC Reader which
must be observed during operation, storage and transportation of the device.
4.5.1 Temperature
 Operating
o Range: ÷25 °C to +60 °C / ÷4 °F to 140 °F
 Storage and Transportation
o Range: ÷25 °C to +60 °C / ÷4 °F to 140 °F
4.5.2 Humidity
The NFC Reader may be operated, stored and transported in 10-95 % Relative Humidity
(non-condensing).
4.5.3 Water Spray
The NFC Reader fulfils IP65 (according to EN60529) from the front-side, when mounted
according to the instructions. Please refer to section 5.2 for further details.
The back-side of the reader, incl. the part of the four sides which is ‘behind’ the gasket
when the device is mounted according to the instructions, should not be exposed to water.
4.5.4 Shocks and Blows
The NFC Reader fulfils IK09 (according to EN62262), when mounted according to the
instructions. Please refer to section 5.2 for further details.
4.5.5 Installation altitude
The NFC Reader is designed for installation up to 2’000 m above sea level.
4.6 Approvals, Certifications and Compliance
The NFC Reader is approved and certified as stated below.
Note! At the time of writing, the NFC Reader is undergoing various approval and
certification processes. The current document will be updated with the relevant
approval references when available.
4.6.1 PCI PTS
 PCI PTS 5.x
o Approval reference: 4-80048
o Device category: OEM SCR
o Supported features: CTLS and SRED
4.6.2 EMV
 EMV Contactless Level 1
o Approval number: 16862 1219 260 26b 26b LGAI