Owner's Manual

SWRVW-52 Module SWRVW-52 Harness SWC Cables
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.020320
SWRVW-52
Radio Replacement with Steering Wheel Control Retention
for Select Volkswagen Vehicles
1 of 2
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Volkswagen vehicles while funconing with an aermarket radio.
- Supports amplied and non-amplied systems.
- EIA color coded wiring for easy installaon.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
Reverse Red/White













TO FACTORY
HARNESS
12-Pin
Connector
1 2 3
ON
4-Pin
Connector
3.5MM SWC CABLES (Option A or B)
Use the proper 3.5MM to 4-Pin cable for your radio.
Plug in the selected 3.5MM SWC cable to the 4-pin
port on the module. See “DIP SWITCH SETTINGS” section.
mini USB
Not Used
CRUX
Option A:
Option B:
Cap or insulate if
not being used
BLUE / YELLOW FOR JVC & KENWOOD
Insulate with
tape if not
being used
NOTES:
1. Driver informaon display will show the last informaon that was shown prior to removing the factory radio.
2. This interface does not retain the factory Bluetooth or Sirius Satellite Radio.
3. The radio is designed to shut o when the key is removed.
4. 2010 and Up vehicles with a premium sound system do not retain the RAP feature.