Owner's Manual

RADIO REPLACEMENT
R
INTERFACING SOLUTIONS
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: [phone] • fax: [phone] • www.cruxinterfacing.com
rev.031220
SOOCR-26
Radio Replacement for
CHRYSLER, DODGE and JEEP Vehicles
2 of 3
AFTERMARKET
RADIO
VSS (Vehicle Speed Sense) Pink
Illumina�on (+) Orange
Power Antenna Blue/ White
Reverse Trigger* Puple/White
+12V Constant Yellow
+12V ACC Red
Ground Black
TO FACTORY
HARNESS
12-Pin Black
Connector
Second Generation Harness
AMPLIFIED
NON AMPLIFIED
*Does not supply Reverse Trigger on Manual Transmissions. Reverse trigger
wire from the aftermarket radio and/or camera power must be connected to
factory reverse light wire instead.
See below for
speaker wire
connections
Audio
Filter
2nd Generaon Harness
NON AMPLIFIED SYSTEMS AMPLIFIED SYSTEMS
Plug the 4-pin Molex connector to the NON-AMPLIFIED
side of the inline lter.
Plug the 4-pin Molex connector to the AMPLIFIED
side of the inline lter.
Wire Connecons: Wire Connecons:
Aermarket Radio SOOCR-26 Harness Aermarket Radio SOOCR-26 Harness
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Green
Green/Black
Purple
Purple/Black
Not Used
Not Used
Not Used
Not Used
Speaker wire connecons:
Wire the audio lter using the connecon chart below. Plug the 4 pin Molex plug found on the 1st or 2nd
generaon harness to the corresponding 4 pin Molex socket on the audio lter. (Amplied or Non-Amplied)