Owner's Manual

&UX[,QWHUIDFLQJ6ROXWLRQV&KDWVZRUWK&A 91311
SKRQHID[ZZZ.cruxinterfacing.com
rev.041222
2 of 4
INSTALLATION DIAGRAM:
AFTERMARKET
RADIO
CS-TJ20 MODULE
1 2 3
ON
1 2 3
ON
AFTERMARKET
RADIO SELECTOR
(See Chart)
GAIN
ADJUSTMENT
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Output Orange
Amp Turn-On Blue/ White
Antenna Turn On Blue
Vehicle Speed Sense Output
Red/Black or Pink
Parking Brake Output Brown
Reverse Gear Output Red
Right Front + Gray
Right Front - Gray/Black
Left Front + White
Left Front - White/Black
Audio Input Red/White RCA
(Retains Factory AUX Input)
12-Pin Black
Connector
Cap or insulate if
not being used
BLUE / YELLOW KENWOOD / JVC SWC WIRED
3.5MM SWC CABLES (Option A or B)
Use the proper 3.5MM to 4-Pin cable for your radio.
Plug in the selected 3.5MM SWC cable to the 4-pin port
on the CS-TJ20 module.
Insulate with tape
if not being used
From CS-TJ20 Harness
To CS-TJ20 Module
CS-TJ20 Module
To Aftermarket Radio Camera Input
To 2 Pin Camera Power Connector
on CS-TJ20 Harness
CS-TJ20 OEM Camera Retention Harness
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Output Orange
Amp Turn-On Blue/ White
Antenna Turn On Blue
Right Front + Gray
Right Front - Gray/Black
Left Front + White
Left Front - White/Black
Audio Input Red/White RCA
(Retains Factory AUX Input)
To CS-TJ20 Module
RADIO REPLACEMENT MODULE
TOYOTA
For JBL Amplied Systems
www.cruxint
erfacing.com
SWCGAIN
AFTERMARKET
RADIO
TY-B
Harness
TY-A
Harness
CS-TJ20 OEM Camera
Retention Harness
(See Below)
Yellow RCA
(To Aftermarket Radio Camera Input)
To 24-Pin OEM
Camera Harness
16 to 24 Pin Camera Adapter
The CS-TJ20 includes a camera harness with a 12V to 6V voltage converter to retain the OEM camera (if equipped).
Some older models use a16-Pin OEM camera connector. In this case, use the supplied 16 to 24-Pin Camera Adapter.
24-Pin
Option A:
Alpine, Clarion, JVC and Kenwood units
Option B:
Blaupunkt, Boss, Dual, Farenheit, Jensen, Pioneer,
Power Acoustik, Sony, Soundstream & most o-brand Radios
NOTE: Aftermarket radio rear speaker output leads are not used on both harnesses. Insulate with tape.