User Manual

17
3:
Upper manual preset 4 ► expression pedal midi channel 1.
With this button you can choose if expression pedal works or not on midi channel 1 (upper
manual).
4:
Upper manual preset 5 ► global transpose –1.
Upper manual preset 6 ► global transpose +1.
With these two buttons it is posible to adjust global transpose of the instrument ( upper and
lower manual) of Mojo with –12/+12 semitones range; pressing “global transpose –1”
button the instrument will decrease with a semitone (led on it will turn on for indicate that
transpose - is active), pressing “global transpose +1” button the instrument will increase
with a semitone (led on it will turn on for indicate that transpose + is active). When
transpose is 0 (OFF) both leds are off.
5:
Manual Upper ► Rotary simulation on/off - control change 53.
With this button is it possible to enable/disable the internal rotary speaker simulation for
example for connect a genuine rotary speaker to the instrument.
6:
Pedal to Lower ► Panic!
If you hold this button for 3 seconds, Mojo will send a “all notes off” message to all 16 midi
channels and then will reboot the midi processor.
7:
Lower manual preset 1 ► program change midi channel 2–.
Lower manual preset 2 ► program change midi channel 2+.
With these two buttons it’s possible to send midi messages of program change on channel
2 both on internal mojo software both on midi out and USB out. Pressing “-“ or “+” you
send messages in a descending or ascending way from 0 to 127. When you reach
program change 0 led on button “program change channel 2 –“ will turn on and is not
possible decrease anymore, same when you will reach 127: led on “program change
channel 2 +” wil turn on and is not possible to increase anymore.
8:
Lower manual preset 3 ► sustain pedal midi channel 2.
With this button you can choose if sustain pedal works or not on midi channel 2 (lower
manual).
9:
Lower manual preset 4 ► expression pedal midi channel 2.
With this button you can choose if expression pedal works or not on midi channel 2 (lower
manual).
10:
Lower manual preset 5 ► rotary connection temporary/latched.
With this button it is possible to set the principle of working of the rear socket “rotary
speed” in case you connect and device with temporary or latched behaviour.