User Manual

16
By pressing “SHIFT” button on the control panel, you can access the “edit” mode:
CRUMAR MOJO will enter programming mode and few buttons, knobs and drawbars take
an alternative function. When “shift” is activated, LEDs on “shift” and on “pedal to lower”
buttons will blink.
Functions associated are a lot, from global settings of the instrument to settings related to
VB3 HE II.
GLOBAL EDIT FUNCTIONS.
Pressing “shift” and pressing buttons as on fig. 4, you can access global intrument
settings. Data will be saved when you exit edit mode pressing “shift” button (related leds
turns off).
Fig. 4
1:
Upper manual preset 1 ► program change midi channel 1 –.
Upper manual preset 2 ► program change midi channel 1 +.
With these two buttons it’s possible to send midi messages of program change on channel
1 both on internal Mojo software both on midi out and USB out. Pressing “-“ or “+” you
send messages in a descending or ascending way from 0 to 127. When you reach
program change 0, led on button “program change channel 1 –“ will turn on and is not
possible decrease anymore, same when you will reach 127: led on “program change
channel 1 +” wil turn on and is not possible to increase anymore.
2:
Upper manual preset 3 ► sustain pedal midi channel 1.
With this button you can choose if sustain pedal works or not on midi channel 1 (upper
manual).
6) EDIT AND PROGRAMMING MODE.