User Manual

Crumar Seven User s Manual '
8.2. CONTROL PANEL: THE EFFECT SECTION.
As seen in the previous chapter, all effects can be turned on or off by means of a slow push on a knob. The effects sections FX1 and FX2
offer a choice of 4 effects each. To select an effect, push the SEL button and the LED will show which effect has been selected. Effects
can also be selected when the FX section is off. In this case, at the first push of the SEL button the LED just shows the current effect,
then turns off after three seconds. If the SEL button is depressed again within three seconds, the selection shifts to the next preset.
Effects are explained in detail later in this manual.
8.3. CONTROL PANEL: TRANSPOSITION.
The transpose button is labeled with a small keyboard icon and has a red LED that turns on whenever the transposition is active.
Transposition is always zeroed every time the instrument is turned on. To change the transposition between -12 and +12
semitones, just press and hold the transpose button and play a note around the middle C. To reset, use the middle C or keep the
transpose button depressed for 3 seconds until the LED goes off.
Crumar Seven User's Manual - Page 19