User Manual

Crumar Seven User s Manual '
CHAPTER 8. CONTROL PANEL: USING KNOBS AND BUTTONS.
In the previous chapter we've learned how the knobs work and what they do, now let's see the rest of the controls.
8.1. CONTROL PANEL: THE PRESETS.
As you can see from the above picture, the center section consists of a group of big buttons used to store and recall our presets. There's
a BANK button that cycles between 4 banks of 8 presets each, that can be recalled or stored using the 8 numbered buttons. The first
bank, with a red LED, is a factory read-only bank containing presets that can't be overwritten by the user. Each factory preset uses one
of the 8 modeling engines, clearly labeled above the button. The remaining 3 banks, with yellow LEDs, can store user presets.
– To recall a preset, select the bank by pushing the BANK button, the LED starts blinking, then push the desired preset number.
– To save a preset, first select a user bank (those with yellow LEDs) then push and hold the desired preset button for at least 3
seconds, until you see an LED animation.
If the bank button has been depressed but no preset has been recalled within three seconds, the previous bank number is restored and
the LED stops blinking. PLEASE NOTE: The Seven will always start with preset 1-1 every time it is turned on.
The table at the next page shows a description of all factory presets.
Crumar Seven User's Manual - Page 17