User manual

3. THE COMMAND PANEL – part 1
In this chapter we get familiar with the command panel of the Mojo 61; for a better
readability, the panel has been split into three parts. Numbers are used to reference
to each control later in this manual.
1. Volume knob.
2. Drive knob, adjusts the overdrive level when the Rotary Speaker effect is active
on VB3 and when a Static Amp is active on Combo organs or Electric Pianos.
3. RUN/STOP: press to stop the rotation of the Rotary Speaker effect, the
corresponding LED will turn on; press again to re-start the rotation, the LED will
go off.
4. SLOW/FAST: press to switch between the two speeds of the Rotary Speaker
effect. The corresponding LED animates accordingly. Please note that the LED
animation is not synchronized with the sound, it's only there for a better visual
feedback. When the STOP speed is engaged, the LED animation halts.
Depressing this button while in STOP mode will switch the speed and the LED
will start animating again, even though there will be no effect on the sound until
the STOP is disengaged using button n. 3.
5. This LED indicates that the support for the optional “Half-Moon” switch has been
enabled, in this case buttons 3 and 4 are unresponsive. To enable and disable the
“Half-Moon” support, press buttons 3 and 4 together.
6. Press this button to switch cyclically between the Vibrato/Chorus options. When
playing VB3, there are 6 options (C1, C2, C3, V1, V2, V3); when playing the Combo
organ “Compact DeLuxe” , only 4 options are available (labeled with smaller
characters, explained later).
7. This button enables/disables the Vibrato/Chorus effect on the selected manual.
CRUMAR MOJO 61 USER'S MANUAL - Page 8/33
Fig. 1 - Command Panel part 1