User manual

7. CONNECTING CONTROL ACCESSORIES
There are three additional Jack sockets on the back of the Mojo 61 that are used to
connect pedals or the “half-moon” 3-way switch.
9. Half-Moon or Foot Switch input socket. Here you can connect our dual foot
switch or our half-moon switch; the latter can only be attached to the optional
lower manual keyboard, and is activated by pushing buttons n. 3 and n. 4
together. Normally, this socket accepts the dual foot switch that works
concurrently with the panel buttons n. 3 and n. 4. Please make sure to use a foot
switch specifically made for the Mojo 61.
10. Connect a 10-K ohm expression pedal to this jack; our Crumar long-throw pedal
is the perfect choice, but other third party pedals might be compatible as well.
11. Connect a traditional sustain pedal to this jack; the polarity is automatically
detected when the instrument is powered on, so please make sure that the
pedal is already connected before powering on.
ABOUT THE SUSTAIN PEDAL
The sustain pedal is normally used when the Electric Piano sound is active and
functions as a normal piano sustain pedal. However, when VB3 is active and the
Rotary Speaker effect is on, the sustain pedal can be configured in a variety of ways
by selecting the proper option in the editor's home page. It can switch Rotary speeds
in latched or momentary mode, sustain the upper, the lower or both manuals, or just
send the MIDI CC # 64 (pedal hold as per General Midi specifications).
8. HOW TO TURN THE MOJO 61 ON
The Mojo 61 comes with an AC cable, one end goes to the power
outlet, the other end goes to the power socket on the back of the
instrument, labeled with number 13.
Push the switch n. 12, after a second you will see all the lights
illuminating the control panel, and after 8 more seconds the
instrument is ready to be played.
CRUMAR MOJO 61 USER'S MANUAL - Page 12/33
Fig. 6 - Pedal inputs.
Fig. 7 – Power section.