manual

Product Description
The new USB DataPort is the latest in removable and mobile data
solutions from CRU-DataPort. The USB DataPort enables users to hot
swap any standard 3.5” low profile IDE/PATA hard disk drive from a
computer’s 5.25” drive bay. The ability to hot swap or “hot plug” hard
drives is ideal for performing data backups at any time without the
inconvenience of a system reboot. Users can also “hot mount” any new
drive volume, meaning it will be recognized by the OS without needing
to reboot.
Please note, removing hard drives during operation is not intended
for primary or boot drives. The USB DataPort uses a DataPort V style
removable drive carrier. The receiving frame is also compatible
with DataPort V+ IDE removable drive carriers, including Encryption
DataPorts for added security.
Package Contents
The USB DataPort kit includes all of the necessary hardware to install
a 3.5” hard drive in a USB DataPort carrier and the USB DataPort frame
in a 5.25” drive bay. Before installing, please verify that the following
items have been included in the package:
Quantity Description
Preparation for Installation
Note: To prevent data loss, read this manual thoroughly before
installing or operating the USB DataPort.
Before touching any electrical equipment, ground yourself by touching
the metal part of your computer chassis. This discharges static
electricity and helps prevent damage to your computer. CRU-DataPort
is not responsible for damage caused by static discharge.
Tools Required:
• Phillips screwdriver
Other items that will be needed are:
• Computer Users Manual
Frame Installation
1. Power off your computer.
Turn off the computer and disconnect its power cord from
the electrical outlet. Before working on your computer, wait
one minute for any residual energy to dissipate.
2. Remove the cover of the computer.
3. Locate an empty external 5.25” bay.
Identify the 5.25” half-height bay in which you plan to mount
the USB DataPort frame assembly. Remove any filler plates that
may be present.
4. Direct mount the frame assembly.
Slide the frame into the 5.25” bay from the front of
the PC case. Using the screws provided, secure the frame
assembly to the PC case using the frame’s side mounting holes.
5. Rail mount the frame assembly.
If the drive bay requires mounting rails, install one on each side
of the frame. The mounting rails should have come with your
computer system.
Page 1 Page 2
1 DataPort Frame Assembly
1 DataPort Carrier Assembly
2 Metal Covers
4 #6-32 x 3/16 Flat head screws for drive mounting
4 M3x5mm pan head screws for frame installation
2 Keys for Lock
1 USB
Cable with PCI Bracket