manual

2.Install the hard drive in the carrier.
With most hard drives you will slide the hard drive in from
the front of the carrier and connect it to the carrier
board. (See picture 2 for details)
If the hard drive does not fit, remove the screw holding
the circuit board in the carrier. Place the hard drive in
the carrier, then connect the circuit board to the hard
drive. Secure the circuit board with the screw and then
secure the hard drive with the provided screws. (See
Picture 3 for details)
3. Attach the Temperature Control Cooling Sensor (TCCS)
to the top of the hard drive with an adhesive strip. After
the drive has been installed, replace the top cover and
secure it with the provided nylon screw.
Page 5
Picture 2
Picture 3
4.Insert the carrier into the frame assembly.
Ensure that the lock of the DataPort is in the “open”
(vertical) position. Position the carrier on the guide rails,
and then slide the carrier into the frame. Using thumb
pressure, fully seat the carrier in the frame and lock the
unit with the key lock.
You have finished the installation and your
DataPort 10 is ready for operation.
Operation
Turn on the Power
The lock on the DataPort locks the carrier in place and
also serves as the power “ON/OFF” switch. Turn the
lock 90 degrees clockwise to the “ON” position before
turning on the computer. When the computer is turned
on, the “Power On” LED (green light emitting diode
above the key on the frame assembly) is illuminated,
and your system should operate normally.
Activity LEDs
The DataPort 10 supports the Serial ATA II drive activity
feature. If the hard disk drive does not support Serial
ATA II the LED activity will be determined by the hard
disk drive; usually the LED will be off.
Page 6