User manual

BASIC OPERATIONS
Programming scan
Setup the frequency of L1 channel, U1 channel, L2 channel and U2 channel will realize VFO frequency
scanning border limited. L1 & L2 is starting frequency, U1 & U2 is end frequency. When VFO frequency
between L1~ U1 or L2 ~ U2, transceiver will scan frequencies between L1 ~ U1 or L2 ~ U2. When VFO
frequency is lower than L1 or L2, transceiver will scan frequencies higher than L1 or L2. When VFO
frequency is higher than U1 or U2, transceiver will scan frequencies higher than U1 or U2.
In VFO mode, enter desired frequency and relative setup, press
1.
key, the top left corner of LCD
displays " " icon, then press key switch into channel mode, channel number flashes
Rotate channel switch to choose desired channel number.
2.
Press
3.
key, the top left corner of LCD displays " " icon, then press key until transceiver emits
"DUDU" beep, channels are saved successfully.
NOTE: To make this setup, L1 and U1 must in same frequency band. L2 and U2 must in same band.
Rotate channel switch to select desired deleting channel number.
2.
Press
3.
key, the top left corner of LCD displays " " icon, press and hold key until transceiver
emits "DUDU" beep and clear up frequency information of current channel, deletion is successful.
NOTE: This process can be applied for deleting FM radio channels.
15