Installation Guide

Chelsea Mirror Fitting Instructions
Thank you for purchasing this Croydex product. Please follow the fixing and care
instructions to ensure that your accessory is fitted safely and that it retains its high
quality finish. Please retain this leaflet for future reference.
Fixing Pack Contents
Long Fixing Screws x 2 (4) (Double Mounting)
Wall Plug X 2 (4) (Double Mounting)
Wall Fixing Bracket x 1 (2) (Double Mounting)
Contents supplied will vary depending on the product. The quantities shown above
in brackets are for double bracket fixings.
NOTE - The wall plugs supplied are for solid walls only, use appropriate
fixings for cavity walls
Tools Required
Drill; Pencil; 6mm masonry drill bit; 6mm ceramic drill bit (optional); Spirit Level;
Small flat head screwdriver; Cross head screwdriver; Tape measure
KEEP DIY TOOLS OUT OF THE REACH OF CHILDREN
Safety and Care Advice
1. Always take care when using an electric drill, particularly in the bathroom.
Always check for hidden cables and pipework before drilling. Always use a
residual current circuit breaker (RCCB) when using mains powered tools and
take extreme care if there is any water in the working area.
2. Always wear suitable eye protection when drilling.
3. If the product is to be fitted on a ceramic tiled wall, a ceramic drill bit should be
used. Do not drill mounting holes in the grouted area between tiles. Mask the
area around the hole with tape before drilling to prevent damage to the tile.
4. Do not use the product as a grab bar.
Instructions for items with single and double mounting point:
1. Select position of product and mark its centre on wall. (Refer to Fig. 1 for
centre positions of double mounting items.) Centre the wall fixing bracket over
the mark and using it as a template mark the screw fixing positions on the wall
surface.
2. Drill the holes to a depth of 40mm in the marked positions using a 6mm
masonry drill. If the product is to be fitted onto a ceramic tiled wall, a ceramic
drill bit should be used.
3. Insert the wall plugs flush to the surface of the wall. If fitting to a tiled surface,
the wall plugs should be inserted below the surface of the tile to avoid
cracking.
4. Insert the screws provided through the wall fixing bracket and screw into the
wall. Ensure the wall bracket is level.
5. Using a small flat head screwdriver loosen the grub screw within the backplate.
Place the backplate on the wall bracket and tighten the grub screw as shown in
Fig. 2.