Installation Guide

4. Insert the screws provided through the wall fixing bracket and screw into the
wall. Ensuring the wall bracket is level.
5. Using a small flat head screwdriver loosen the grub screw within the
backplate. Place the backplate on the wall bracket and tighten the grub screw
as shown in figure 2.
Fig. 1 Fig. 2
Instruction for Mirror Fixing
6. Once the brackets are in position and correctly centred, place the rubber
grommets through the holes in the mirror glass from the rear.
7. Carefully line up the mirror holes with the wall bracket studs and position the
mirror in place over the studs shown in figure 3. Make sure that the rubber
grommets are not displaced. If the hole centres do not line up adjust the wall
bracket centres accordingly.
8. When the mirror glass is in position screw on the brass bushes.
DO NOT OVERTIGHTEN.
9. Press the mirror knobs over the brass bushes and rotate as required to
achieve the desired orientation.
Fig.3
Additional Information
• Maximum safe working load for the shelf is 5kg. This load must be evenly
distributed across the surface area of the shelf.
Product Care Advice
• To retain the best quality finish, clean product regularly with a soft damp cloth.
• Do not use abrasive or chemical cleaners, as these will damage the product.
• Do not place hot objects onto the surface of the glass.
• Do not position glass components in close contact with a heat source
Please retain this leaflet for future reference.
Croydex Limited, Central Way, Andover, Hants, SP10 5AW, UK
Tel: [phone]. Fax: [phone]
Website:
www.croydex.co.uk. E-mail: [e-mail].
WMA 001 R02