Installation Guide

7. Mark the positions of the joint inserts and then place the rod carefully onto a flat surface. Position
the alignment guide onto the end of the joint with the flat face of the alignment guide facing
downwards. (See Fig.7) Rotate the joint until it is aligned with the rod and tighten the expansion
joint using the hex head key provided. (See Fig.8) Repeat for the opposite end.
8. Replace the rod to check the alignment of the flexible joint screw holes. If adjustment is required,
undo the expansion joint screw by 2 or 3 turns and hit the end of the hex head key with a
hammer. This will release the cone insert allowing correct adjustment to be made. DO NOT
FULLY UNWIND THE HEX HEAD SCREW.
9. Slide the wall bracket and the ball covers onto the rod, noting the orientation of the covers. (See
Fig.9) Place the O-ring over the end of the joint, locating it into the annular recess. (See Fig.10)
10. Assemble the rod to the wall bracket swivel inserts ensuring the curve of the rod is pointing into
the room. Place the plastic bush between the two halves of the flexible joint and screw them
tightly together. (See Fig.11 & 12)
11. Once the rod is in position carefully slide the ball cover over the flexible joint until it engages with
the O-ring. Slide the wall bracket cover over the wall bracket, aligning the two tabs at the back of
the cover with the two recesses in the wall bracket. (See Fig.13 &14) Twist the cover clockwise
to secure in position. (See Fig.15)
12. Hook the Rod Reacher onto the rod and rotate the rod to check the assembly is working
correctly.
Product Care Advice
To retain the best quality finish, clean product regularly with a soft damp cloth.
Do not use abrasive or chemical cleaners, as these will damage the product.
Please retain this leaflet for future reference.
Croydex Ltd, Central Way, Andover, Hants, SP105AW, UK
Tel: [phone] ~ Fax: [phone]
website: www.croydex.com ~ Email: [e-mail]
R&R 039 R02