Instructions / Assembly

Step 4
Install J-Trims on each side of the first panel. Use a level to make sure
the trim is perpendicular to the panel. Screw through both the upper
channel of the panel and the J-Trim into the start and finish studs.
The longer side of the J-Trim should be flush to the wall.
Step 5
Slightly curve and slide your next panel into the J-Trim. Clip the next
panel into the previous one. Be sure to screw through the upper
channel and into each stud (16” apart or 41cm) before clipping in the
next panel. Continue this step until all panels are installed.
Step 6
Install your top trim by simply clipping it into the top of your final
panel.
*CONCRETE OR CINDER BLOCK WALL INSTALLATION*
To fasten your CrownWall directly to concrete
or cinderblock:
- Predrill holes with concrete bit
- Fasten CrownWall with 2” (5 cm) flathead tapcons
Questions or missing parts? Contact our customer service department at
Top Trim
[e-mail] or 1-866-291-6982
CrownWall
4’ x 8’ Panel Kit