Specifications

page 9
Studio Reference I & II Professional Studio Amplifiers
Operation Manual
R eference
STUDIO
CH-2 CH-1
PUSHPUSH
FX
MIXER
STUDIO REFERENCE
AMPLIFIER
+
–
+
–
CHANNEL 1
LOUDSPEAKER
CHANNEL 2
LOUDSPEAKER
CHANNEL 1
CHANNEL 2
CAUTION: TURN OFF AMPLIFIER
BEFORE CHANGING THIS SWITCH!
STEREO
BRIDGE
MONO
PARALLEL
MONO
2.6 Wire Your System
2.6.1 Stereo Mode
Typical input and output wiring is shown in
Figure 2.8.
Turn off the amplifier and set the
Stereo/Mono Switch to Stereo.
INPUTS: Connect input wiring for both channels.
NOTE: Crown provides a reference of wiring pin
assignments for commonly used connector
types in the Crown Amplifier Application Guide
available at www.crownaudio.com.
OUTPUTS: Each output channel has two sets of
binding posts to make it easier to connect multi-
ple loudspeaker cables to each channel.
Maintain proper polarity (+/–) on output connec-
tors.
Connect Channel 1 loudspeaker’s positive (+)
lead to Channel 1 positive (red) terminal of amp;
repeat for negative (–). Repeat Channel 2 wiring
as for Channel 1.
CAUTION: In Stereo mode, never tie an
amplifier’s outputs together directly, and
never parallel them with the output of
another amplifier. Such connections do not
result in increased output power, but may
activate the protection circuitry to prevent over-
heating.
2 Setup
Figure 2.8
Stereo Wiring