Setup guide

Network
Configuration
45
QMS CrownNet Setup Guide
5 In the CrownNet Print Utility, select the Windows port you
just installed.
If the printer Status shows No Response, you can either wait up
to 15 seconds for the status to change or, after about 15 seconds,
choose the Refresh command to display a message such as OK,
Busy, Offline, Occupied, or Out of Paper. If the No
Response message persists, or if an Internal Error
message displays, either refer to the CrownNet Print Utility on-
line help for advice on further action or close the utility and restart
it.
6 In the Port menu, choose Connect to bring up the Printers
dialog box.
7 Select a printer from the list of Printers, and then from the
File menu choose Properties.
» Note:
If you double-click (instead of single-click) on the printer
driver to display the printer driver dialog box, the Properties
command is located in the Printer menu.
If the printer is not listed, choose Add Printer to install a new
printer. This opens the Add Printer Wizard.
» Note:
When adding a printer, keep the following two points in
mind:
n When asked how the printer is attached to your computer,
choose Local Printer,
not Network Printer.
n When asked what port you want to use with the printer, select
the Windows port you installed in steps 2-4. It will be in this
format:
drive :\ directory \ port , where drive is the spooling drive,
directory is the spooling directory, and port is the CrownNet
Windows port name.
8 In the Properties dialog box, choose the Details tab.
9 In the Print to the Following Port drop-down list box, select
the Windows port you installed in steps 2-4, and choose OK.
The Windows port name will near the top of the Ports list and will
be in this format:
drive :\ directory \ port , where drive is the spooling