Setup guide

Network
Configuration
41
QMS CrownNet Setup Guide
7 Select a printer driver from the list of Installed Printers (or
choose Add>> to install a new driver), and then choose
Connect...
8 In the Connect dialog box select the Windows port you
installed in steps 2-4, and choose OK.
The Windows port name will be at the bottom of the Ports list and
will be in this format: drive :\ directory \ port , where drive is the
spooling drive,
directory is the spooling directory, and port is the
CrownNet Windows port name.
9 Choose OK to close the Connect dialog box, and then
choose Close to close the Printers dialog box.
The setup is now complete, and you can immediately print through
your CrownNet port. Refer to the
QMS CrownNet System Administra-
tor’s Guide
for additional information on setting up serverless and cli-
ent-server (server-based) printing.
» Note:
The QMS CrownNet Print Utility must be running when you
print to your CrownNet port. We strongly recommend that, if you
haven't already, you place the CrownNet Print Utility
(CROWNPUW.EXE) into your Startup folder.
Windows NT
» Note: Windows NT requires preinstallation of the Microsoft Windows
Network running the NetBEUI Protocol, NetBIOS Interface, and
Workstation and/or Server network software. Refer to your Windows
documentation for installation instructions.
1 Double-click the CrownNet Print Utility icon to start the util-
ity.
2 In the Port
menu, choose Add.
3 In the CrownNet Port list, select the CrownNet port you want
to install.
The ports appear as an alphanumeric list of printers attached to
the network. The names of these printers are defined in the
Administration/Communications/
xxxxxxxx NIC/CrownNet/Lan
Manager/Printer Name menu (where
xxxxxxxx is either Resident