Setup guide

Interface
Configuration
QMS CrownNet Setup Guide38
2 Reset the CrownNet interface by using the Administration/
Communications/
xxxxxxxx NIC/CrownNet/Common/Soft
Reset menu (where
xxxxxxxx is either Resident or Optional).
3 Skip to “Network Configuration” on page 39.
TCP/IP Interface Configuration
1 If necessary, in the Administration/Communications/
xxxxxxxx NIC/CrownNet/TCPIP/Internet Address menu
(where
xxxxxxxx is either Resident or Optional), enter the
printer’s Internet address.
The factory default Internet address is 161.033.128.024.
2 If necessary, in the Administration/Communications/
xxxxxxxx NIC/CrownNet/TCPIP/Default Router menu (where
xxxxxxxx is either Resident or Optional), enter the Internet
address of the default router.
The factory default router address is 000.000.000.000.
3 If necessary, in the Administration/Communications/
xxxxxxxx NIC/CrownNet/TCPIP/Subnet Mask menu (where
xxxxxxxx is either Resident or Optional), enter the printer’s
subnet mask.
The default subnet mask is 000.000.000.000. This setting
provides automatic sensing of gateways. If you identify a subnet
mask, automatic sensing is disabled.
4 Go to “Network Configuration” on page 39.