Setup guide

Software
Installation
QMS CrownNet Setup Guide20
7 Change to the location in which you want the CrownAdmin 3
directory to be created.
» Note:
The directory in which crnadm.exe resides must be able to
be mounted by all network nodes that need to access the printer.
8 Extract the appropriate files from the CD-ROM.
n For example, if you're running HP-UX version 9.
x , type
tar xvf /cdrom/platform/unix/crnadm/hp_ux/
hp9.tar↵
n For example, if you're running HP-UX version 10.
x , type
tar xvf /cdrom/platform/unix/crnadm/hp_ux/
hp10.tar↵
This creates a crnadm directory containing CrownAdmin 3.
» Note:
See the main readme file on the CD-ROM for the exact
location of this file.
9 Unmount the CD-ROM file system:
umount
device_filename ↵
For
device_filename , substitute the complete pathname of the
device file associated with the CD-ROM drive.
10 Add the name of the directory containing crnadm (the direc-
tory in which you extracted the hp9.tar or hp10.tar file) to
your path.
11 Install the UNIX Host Software, following the instructions in
“Installing the UNIX Host Software” on page 30.
Installing CrownAdmin 3 for Macintosh
CrownAdmin 3 for Macintosh is a software utility that allows you to
monitor and configure QMS printers and perform network operations
on printers connected to your network.
1 Insert the CD-ROM in your CD-ROM drive.