Setup guide

Network
Connection
QMS CrownNet Setup Guide16
b Once the printer is on line and the message window reads
IDLE, press the Online/Offline key to take it off line.
c Access the Administration/Communications/
xxxxxxxx NIC/
CrownNet/Common/Ring Speed menu (where
xxxxxxxx is
either Resident or Optional).
» Note:
For complete information on using the control panel,
see your printer documentation.
d Select 4 Mbits/Sec as the network speed.
▲ Caution: Leave the printer disconnected from the network if
you are changing the ring speed.
e Use the Administration/Communications/ xxxxxxxx NIC/
CrownNet/Common/Soft Reset menu to reset the CrownNet
interface (where
xxxxxxxx is either Resident or Optional).
f Connect the printer to the network with the network adapter
cable.
5 The default source routing type (Auto—Send the file as the
most appropriate frame type) is fine for most Token-Ring net-
works.
However, if your network uses a different type of source routing,
identify that now in the Administration/Communications/
xxxxxxxx NIC/CrownNet/Common/Source Routing menu (where
xxxxxxxx is either Resident or Optional). Other choices are
n All—Send as an all-routes-explorer frame, also known as an
all-routes-broadcast frame.
n Off—Send without source routing information.
n Single—Send as a spanning-tree-explorer frame, also
known as a single-route-broadcast frame.
6 Go to “Software Installation” on page 17.