Setup guide

Network
Connection
QMS CrownNet Setup Guide12
Network Connection
The method you use to connect your printer to the network depends
on whether you’re connecting to an Ethernet network (described
below) or a Token-Ring network (described on page 15).
Ethernet Network Connection
n For thin-wire Ethernet (10Base2, BNC connector) see the next
section.
n For thick-wire Ethernet (10Base5, AUI connector)—not available
for some printers—see page 13.
n For twisted-pair Ethernet (10BaseT/100BaseTX, RJ45 connec-
tor) see page 14.
Thin-Wire Ethernet Connection
Thin-wire Ethernet connections use BNC connectors.
▲ Caution: Unless the BNC “T” connector is already installed on the
thin-wire Ethernet cable, your network’s operation is disrupted during
the connection process.
1 Turn off the printer, and unplug the power cord.
2 If the BNC “T” connector is already installed, go to step 3.
Otherwise, attach one section of thin-wire Ethernet cable to
one end of the BNC “T” connector.
BNC 50 Ohm
Terminator
BNC “T”
Connector