Setup guide

Setting up the
CrownNet
Interface
Overview
9
QMS CrownNet Setup Guide
Setting up the CrownNet
Interface—Overview
1 If necessary, install the CrownNet interface card.
This might not be necessary because some printers ship
standard with an Ethernet network interface. Check the printer
documentation if you’re not sure.
For instructions on installing a CrownNet interface card, refer to
the “Printer Options” chapter or the
Options manual of your
printer documentation.
2 Connect the printer to the network.
3 Install the appropriate CrownNet software.
If you use... Follow these instructions...
Ethernet “Ethernet Network Connection” on page 12.
Token-Ring “Token-Ring Network Connection” on page 15.
If you use this
operating
system...
Install this software
(on the CD-ROM)...
Following these
instructions*...
AIX CrownAdmin 3 “Installing CrownAdmin 3 for
AIX” on page 17
UNIX Host Software “Installing the UNIX Host
Software” on page 30
DOS CrownAdmin “Installing CrownAdmin for
DOS” on page 18
HP-UX CrownAdmin 3 “Installing CrownAdmin 3 for
HP-UX” on page 19
UNIX Host Software “Installing the UNIX Host
Software” on page 30
Macintosh CrownAdmin 3 “Installing CrownAdmin 3 for
Macintosh” on page 20