Setup guide
'3/
7'3/
The printer provides a twisted-pair (10BaseT/100BaseTX) Ethernet
interface. Twisted-pair Ethernet connections use RJ45 connectors.
44
This section briefly describes the configuration procedure for the
CrownNet Ethernet printer interface. For a complete discussion of all
of the configuration options available through the Administration/Com-
munications/Resident NIC/CrownNet menu, see chapter 2, “Interface
Configuration,” of the
QMS CrownNet System Administrator’s Guide
.
You can make these configuration changes through any of the follow-
ing means:
Printer control panel—For information on using the printer con-
trol panel to change configuration menu settings, refer to chapter
4, “Printer Configuration,” of the
Reference
manual.
1 Turn off the printer, and unplug the
power cord.
2 Connect one end of the twisted-pair Ethernet
cable to the printer’s Ethernet port.
3 Connect the other end of the cable to the
10BaseT/100BaseTX concentrator.
4 Plug in the printer, and turn it on.
»Note:
In compliance with UL guidelines, “The appliance inlet is
considered to be the main disconnect device.”
!"