Setup guide
#
1 Press the metal plate until
it latches.
2 Squeeze in the retainers
to move the media guide
clips all the way toward the
outer edges.
3 Align the four corners of the
media stack, and insert it
under the fluke at the front
right side, with the print side
facing down.
A fill-limit mark is on the inside
of the cassette.
»Note:
Make sure the top sheet is under the fluke. Do not load
more sheets than the maximum specified.
4 Squeeze the media guide
clips to move them to the
size of the media.
Make sure the media corners
are not bent upward by the
guides.
»Note:
If the guide clip is pressed too tightly against the media, it
may cause a jam.