Setup guide
-
,-.
1 Slide the media cassette
out.
2 Remove the tape and card-
board spacer from the right
side of the cassette.
3 Remove the foam spacer
(labeled “C”) from the
media cassette.
»Note:
You may have to slightly
open the media guide clips.
"
Refer to chapter 2, “Print Media,” in the
Reference
manual for details
on the types of media that are suitable for printing.
1 Take a stack of about 250 sheets (
½ ream).
»Note:
Don’t unpack paper above the printer as this might cause
paper particles to fall into the printer.
2 Holding the stack with one hand, fan the sheets with the
other hand.
This gets air through the sheets and prevents static buildup.
»Note:
Do not fan transparencies.
3 Take off the top and bottom sheets.
These sheets sometimes have residual glue buildup that could
cause a media jam.
C